Pioneers in the industry, we offer dln series switchable sensor, takex through beam sensor, takex slim type light curtain sensor, fs-1000e takex flame sensor, ultrasonic displacement sensors and fd-a300p takex hot metal detector from India.
+ 14 Deg F to + 140 Deg F (-10 Deg C to +60 Deg C)
4.72 inch (120 mm) X H1.57 inch (40 mm)
The FS-1000E Takex Flame Sensor quickly detects ultraviolet rays contained in flames and activates a built-in alarm sound plus an open collector output.
The internal alarm sounder output is greater than 80dB at 3.3ft. (1m) in front of the sensor. The internal sounder can be disconnected by cutting a jumper wire if required when using an external DC power supply.
Compact design enables FS-1000E to be installed at any location. Easy separation of the sensor unit from the base simplifies installation and maintenance.
Low battery: When using a battery power source, low battery condition is annunciated by an internal buzzer and external LED.
Power up: When power is turned on, an alarm sound is activated. If no alarm sound is activated, check the power source.
FD-A300P is a series of optical fiber-type hot metal detection photo sensor (HMD) that directly detect infrared energy emitted from heated material (steel products, etc.). Equipped with a controller that employs an 8-bit microcomputer, this intelligent hot metal detection sensor integrates various functions.
Sensitivity adjustment unnecessary: auto sensing mode Auto sensing mode automatically adjusts the operation level based on the received light intensity at detection of heated material and manual mode that allows manual setting of operation level are available.
One sensor for a wide range of temperatures Two different ranges for low and high temperatures can be switched with external signal and support low and high temperatures.
Numerical indication of received light intensity convenient for operation level setting Received light intensity at detection of heated material is represented in value between 0.1 and 10.0 for arbitrary setting of output operation level. Broad dynamic range of amplifier allows numerical expression of wide range of temperatures of heated materials in analog quantity, which, unlike the conventional HMD sensitivity adjustment, facilitates setting of operation level in concrete figures.
Recall function: received light intensity detected in the past viewable Maximum received light intensity of heated material detected is stored to allow viewing during nondetection. Eight most recent maximum received light intensities of heated materials are stored to allow viewing of previous received light intensities in figures by selecting a mode.